Hi everybody, it's me the ghost...
I was playing a little VDrift last night and made some notes about some issues I found with editing controls.
* Since the values are not displayed for sliders anymore, it's impossible to tell if the Gain setting on controls is set to 1.0.
* When I first set my Gas control it seemed to set strange values for gain and exponent - deadzone was defaulted to 0 while the others had the sliders in a position that would indicate negative values.
* Are the deadzone, gain and exponent for steer left and right automatically matched now? I made changes to Steer Left and then went to change Steer Right but it seemed to be correct already.
It's still pretty hard to set the controls just right...when driving, as I make small adjustments to steering the car tends to dart around instead of make a slight change but still go straight. I tend to set the deadzone pretty low, but make the gain less than 1.0 and ramp up the exponent some so that it compensates for the low gain as the steering angle changes. Still, this doesn't quite smooth it out totally. Any suggestions?
