Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Logitech G25 Wheel not fully supported under Linux
03-01-2008, 12:31 PM,
Logitech G25 Wheel not fully supported under Linux
Hi, all.

Last year, there was a discussion on that subject, and some of you guys had succeeded in correcting this bug (Kada, if I remember well)
through a small patch in the usbhid module.
I can't find this correction anywhere, even on linux input, so could you share it, please ?

My pb seem to be close of what you were saying :
- the grid is not working, except for the 1st and 2nd gear,
- in sequential mode, OK, with the same button ids
as the 1st and 2nd gear in grid mode,
- whatever mode, 2 of the 4 red buttons also have the save ids.

Thanks in advance, guys.
03-01-2008, 06:11 PM,
I haven't heard much about the buttons problems and I can't tell you much because I don't have a G25. A little searching doesn't turn up much, but you might find some useful stuff in these threads: set to 900 degree mode force feedback stuff
03-02-2008, 02:03 PM,
I'll take a close look at these threads as soon as I can.
Thanks a lot for your time and help.

Forum Jump:

Users browsing this thread: 1 Guest(s)