Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
joystick/wheel axis config
08-18-2006, 02:16 PM,
#16
 
The UpdateCalibration action is used when the OK button is pressed on the Joystick Calibration menu. The actual calibration is done by the Calibration widget that appears on the Joystick Calibration menu, and has graphs of the joystick axis ranges with blue fill representing the area that has been reached by the moving axes.

The JoystickCalibrate action is just used to change to the Joystick Calibration menu. That's the name of the menu file as well as the name of the menu itself.

Again, all you should have to do is go to the Joystick Calibration menu, wiggle your joystick(s) around until the blue area won't get any bigger, then click OK.

If this is not working for you, are you sure that VDrift is recognizing your joystick device? When you run VDrift from the command line, it reports how many joysticks are connected and usable by the game as it starts up. It will look something like this:
Code:
1 joystick(s) found:
    0. Logitech Inc. WingMan RumblePad
Reply
08-19-2006, 07:35 AM,
#17
 
ok, i found the problem, to find out how the menu structure works i just disabled the the mouse and joystick in the main loop, but forgot to enable it again after find out that i had to use "positive" and "negative" instead of "true" and "false". so no event came trough and the calibration wasn't working. so just my fault, but thank you anyway.
Reply
08-19-2006, 07:35 AM,
#18
 
ok, i found the problem, to find out how the menu structure works i just disabled the the mouse and joystick in the main loop, but forgot to enable it again after find out that i had to use "positive" and "negative" instead of "true" and "false". so no event came trough and the calibration wasn't working. so just my fault, but thank you anyway.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)