Wheel position and suspension travel

[joevenzon]

Rising rate springs has been mentioned, has this been implemented at all?

Yes, in R2524. :-)

Code:

spring-factor-1 = 0.052, 1.0
spring-factor-2 = 0.055, 1.2

The spring-factor-1 and 2 parameters define a curve for the spring response. These can be omitted if desired, in which case a factor of 1.0 will be used everywhere. Points are defined by specifying an x,y pair where x is the suspension displacement in meters and y is the factor to be applied to the spring coefficient. In this example, the spring factor will be 1.0 when the displacement is between 0 and 0.052 m, and then the spring factor will change linearly to 1.2 at 0.055 m (and beyond). The spring factor gets multiplied by the spring-constant. You can put as many spring-factor points as you want (just increase the spring-factor- number for each additional point). Note that displacement values are relative to the "zero g", "zero force" position. For best results, start VDrift with the -debug option and observe suspension displacements during maneuvering to determine where you want to put your points.