Forums › Community › Help v
Speedo in KM/h?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Speedo in KM/h?
04-27-2007, 12:03 AM,
#13
winno Offline
Junior Member
**
 		Posts: 7
Threads: 0
Joined: Apr 2007
 
The "suppressed zero" value is the speed that needle deflection starts to occur. It is meant to model real life gauge markings which often start at zero but immediately jump to 10 km/h or 5 mph with no spacing, so you can't read any speed lower than that.

I'd leave it as being optional, especially if it gets too complex.

I look forward to seeing 3D models of gauges. There's potential for effects like lighting (shadows, night-time backlights). A challenge would be getting the in-dash markings to be readable though.
Find
Reply


Messages In This Thread
Speedo in KM/h? - by reece146 - 10-31-2006, 11:09 AM
[No subject] - by thelusiv - 10-31-2006, 01:42 PM
[No subject] - by reece146 - 10-31-2006, 02:45 PM
[No subject] - by joevenzon_phpbb2_import3 - 10-31-2006, 10:39 PM
[No subject] - by winno - 04-20-2007, 09:02 AM
[No subject] - by thelusiv - 04-20-2007, 02:53 PM
[No subject] - by winno - 04-21-2007, 07:47 AM
[No subject] - by thelusiv - 04-21-2007, 03:35 PM
[No subject] - by winno - 04-22-2007, 03:22 AM
[No subject] - by thelusiv - 04-25-2007, 03:21 AM
[No subject] - by winno - 04-25-2007, 10:20 AM
[No subject] - by joevenzon_phpbb2_import3 - 04-26-2007, 09:53 PM
[No subject] - by winno - 04-27-2007, 12:03 AM
[No subject] - by thelusiv - 04-27-2007, 12:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)