Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Request for additional car data.
01-13-2016, 05:21 PM,
#3
RE: Request for additional car data.
(01-11-2016, 12:14 PM)arturo Wrote: For the Modena:

- The radius and width of each wheel, r_w and w_w.
Rear wheels are 275/40/18. This makes w_w = 275 and r_w = 325
Front wheels are 215/45/18. This makes w_w = 215 and r_w = 312

- The widths of the front and rear axles.
1669 / 1617

- The length of the wheelbase.
2600

- The position of the center of mass of the car body relative to the wheelbase.
1482 from the front axle / 1118 from the rear axle
43/57 % (http://www.zeperfs.com/en/fiche146-ferra...modena.htm)

These were of course the easy ones. For all the other data, I wish you luck. Please let us know if and where you can find them.

Thanks for the data. This is a good start and hopefully
other users will be able to supply the rest of the
requested values.

It seems that if vdrift is accurately simulating the
motion of the vehicle body, and the motion of the wheels,
and other moving parts like the engine, steering system,
etc then the data I requested should be somewhere inside
the vdrift software. Is this correct ?
Reply


Messages In This Thread
Request for additional car data. - by vdriftz - 01-03-2016, 05:33 PM
RE: Request for additional car data. - by arturo - 01-11-2016, 12:14 PM
RE: Request for additional car data. - by vdriftz - 01-13-2016, 05:21 PM
RE: Request for additional car data. - by arturo - 01-13-2016, 10:10 PM
RE: Request for additional car data. - by vdriftz - 01-14-2016, 04:47 AM
RE: Request for additional car data. - by arturo - 01-14-2016, 05:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)