+- Forums (https://www.vdrift.net/Forum)
+-- Forum: Project (https://www.vdrift.net/Forum/forumdisplay.php?fid=4)
+--- Forum: Development (https://www.vdrift.net/Forum/forumdisplay.php?fid=9)
+--- Thread: Logitech G25 Wheel not fully supported under Linux (/showthread.php?tid=920)
Logitech G25 Wheel not fully supported under Linux - pouillot - 03-01-2008
Hi, all.
Last year, there was a discussion on that subject, and some of you guys had succeeded in correcting this bug (Kada, if I remember well)
through a small patch in the usbhid module.
I can't find this correction anywhere, even on linux input, so could you share it, please ?
My pb seem to be close of what you were saying :
- the grid is not working, except for the 1st and 2nd gear,
- in sequential mode, OK, with the same button ids
as the 1st and 2nd gear in grid mode,
- whatever mode, 2 of the 4 red buttons also have the save ids.
Thanks in advance, guys.
- thelusiv - 03-01-2008
I haven't heard much about the buttons problems and I can't tell you much because I don't have a G25. A little searching doesn't turn up much, but you might find some useful stuff in these threads:
http://vdrift.net/Forum/viewtopic.php?t=866 set to 900 degree mode
http://vdrift.net/Forum/viewtopic.php?t=541 force feedback stuff
- pouillot - 03-02-2008
OK.
I'll take a close look at these threads as soon as I can.
Thanks a lot for your time and help.